Quick Test 3in1 combo (Covid19+Gripa A/B), 1 piece, Advent Life

Properties:
The Combo test differentiates between Flu and Covid-19.

Flu or Covid?
The new test kit helps you treat yourself correctly.
Results in 10 minutes.
Easy to interpret results
Storage at room temperature

Considering the fact that it is very difficult to distinguish between the symptoms of Covid-19 and the Flu, the face test comes to help with this differentiation, offering support in the correct and effective treatment scheme.

Covid-19 is an acute respiratory infectious disease caused by SARS-CoV-2. The most common symptoms are cough and fever, but sore throat, headache and muscle pain, as well as general weakness and breathing difficulties can also occur. Nausea, conjunctivitis, swollen lymph nodes and drowsiness, change or loss of taste and smell are some of the less frequent symptoms of the disease.

The flu is characterized by a sudden onset of high fever, cough and sore throat, accompanied by headache and/or muscle and joint pain. The patient may also feel general weakness, chills, sweating, loss of appetite, nasal secretions and nausea. The most common complication of the flu is pneumonia. Flu symptoms usually last more than a week.'

How to use:
Wash your hands with soap and water for at least 20 seconds before and after the test. If soap and water are not available, use hand sanitizer with at least 60% alcohol.
Remove the cap of the extraction buffer tube and place the tube in the tube holder in the box.
Nasal swab sample collection:
1. Remove the sterile swab from the bag. Do not touch the soft tip of the pad.
2. Insert the pad into the nostril until you feel a slight resistance (approx. 2 cm above the nose). Gently twist the swab, rubbing it along the inside of your nostrils 5-10 times on the side of the nasal wall.
3. Gently remove the pad.
4. Using the same swab, repeat step 2 in the other nostril.
5. Withdraw the pad.

Sample preparation:
1. Insert the buffer into the extraction tube, make sure it touches the bottom and shake the buffer to mix well. 2. Press the head of the swab against the tube and rotate the swab for 10-15 seconds.
2. Remove the swab while squeezing the swab head against the inside of the extraction tube.
3. Place the swab in a plastic bag.
4. Close the cap or fit the tip of the test tube.

Testing:
1. Remove the test cassette from the sealed foil bag and use within one hour. Best results will be obtained if the test is performed immediately after opening the foil bag. Place the test box on a flat and level surface.
2. Invert the sample extraction tube and add 3 drops of extracted sample to each sample hole in the test box and start the timer. Do not move the test box during test development.
3. Read the result after 10 minutes. Do not read the result after 20 minutes.

Presentation:
1 piece